Publicidad
Idiomas disponibles
Idiomas disponibles
4.
Release the lock lever and tighten the grip.
3
4
► 1. Grip 2. Lock lever 3. Pointer 4. Miter angle scale
Positive stop function
This miter saw employs positive stop function. You can
set 0°, 15°, 22.5°, 31.6°, 45°, and 60° right/left miter
angle quickly.
1.
Rotate the grip counterclockwise
2.
Press and hold down the lock lever in an unlocked
position.
3.
Turn the turn base close to your desired positive
stop angle and release the lock lever.
4.
Turn the turn base at your desired positive stop
angle until it is secured.
5.
Tighten the grip.
2
► 1. Grip 2. Lock lever 3. Positive stop angle
2
1
3
1
NOTE: To set the turn base free from the positive stop
function, press down the releasing lever. The turn
base can be moved freely without holding down the
lock lever. Swing the grip to turn the turn base to your
desired angle, and then tighten the grip.
1
► 1. Releasing lever
Adjusting the bevel angle
CAUTION:
After changing the bevel angle,
always secure the arm by tightening the knob on
the slide pole clockwise.
NOTICE:
Always remove the upper guide fences
and vertical vise before adjusting the bevel angle.
NOTICE:
When tilting the circular saw blade, be
sure that the carriage is fully raised.
NOTICE:
When changing bevel angles, be sure
to reposition the kerf boards appropriately as
explained in the section for positioning kerf
boards.
NOTICE:
Do not tighten the knob on the slide
pole too hard. Doing so may cause malfunction of
the locking mechanism of the bevel angle.
Tilting the circular saw blade to the
left
1.
Rotate the knob on the slide pole
counterclockwise.
► 1. Knob
16 ENGLISH
1
Publicidad
