Publicidad
Idiomas disponibles
Idiomas disponibles
Tilting the circular saw blade using
positive stop function
This miter saw employs positive stop function. You can
set 22.5° and 33.9° angle to both right and left quickly.
1.
Rotate the knob on the slide pole
counterclockwise.
2.
Tilt the carriage close to your desired positive stop
angle while raising the latch lever up.
3.
Set the latch lever in a horizontal position.
4.
Tilt the carriage at your desired positive stop angle
until it is secured.
5.
To change the angle, pull the latch lever towards
the front of the tool, and then re-tilt the carriage.
6.
Tighten the knob clockwise to secure the carriage
arm.
► 1. Knob 2. Latch lever
2
1
Tilting the circular saw blade beyond
the range 0° - 45°
1.
Rotate the knob on the slide pole
counterclockwise.
2.
Hold the handle and tilt the carriage through 45°
either to the left or right.
3.
Pull the carriage back slightly and slide the releas-
ing lever for 48° bevel angle towards the front of the
tool.
4.
Tilt the carriage further to the left or right while
keeping the lever released.
5.
Tighten the knob clockwise to secure the carriage
arm.
► 1. Knob 2. Handle 3. Releasing lever for 48° bevel
angle
18 ENGLISH
2
1
3
Publicidad
