Cub Cadet 450 Serie Manual Del Operacion página 5

Installing Emergency Stop Control (IF EQUIPPED)
Some models come equipped with an emergency stop control switch. If equipped
you will need to complete installation of this safety feature prior to operating
the tiller.
Use extreme caution when reversing or pulling the machine towards you.
To avoid getting pinned against a structure, ensure adequate distance
before reversing near a wall or fence. For machines with powered reverse
drive capability, familiarize yourself with the operation of the emergency
stop control. It provides a means of stopping power to the tines and wheel
drive in an emergency situation.
1. To finish handle installation locate
the emergency stop control wire on
the right side of the unit behind
the engine.
2. Route the wire up the handle shaft
and secure with cable ties just
above the lower handle adjust
bracket and below the upper handle
adjust bracket. See Figure 4.
3. Route the wire over to the left side
of the handle and secure with a
cable tie on the lower part of the
handle. See Figure 5.
Leave a little extra slack in
NOTE:
the emergency stop control wire
between the cable ties in steps 2
and 3 of this section to allow full
range of motion for the upper
handle adjust.
4. Mount the emergency stop control
ON/OFF switch onto the left side
of the handlebar with the #10-32 :
1.50 hex bolt and 10-32 flange lock
nut. See 1 in Figure 6.
5. Secure the wire near the top of the
handlebar with a cable tie on the
left handlebar. See 2 in Figure 6.
Clutch Cable
Attach the clutch cable to the handle as
follows: (be careful not to kink the cable)
1. Remove the threaded eyebolt and
nut from the cable end.
2. Route the clutch cable to the right side of the handle mounting brackets and
underneath the handle.
ASSEMBLY & SET-UP
WARNING
Figure 4
Figure 5
2
Figure 6
3. Push the cable
through the hole
in the center of the
handle and snap into
the plastic fitting. See
Figure 7.
4. Remove the machine
screw, flange lock nut
and washer from the
clutch control. See
Figure 8.
5. Fasten the threaded
eyebolt onto the
bail by securing it
from the top with
the machine screw,
washer and flange
lock nut.
6. Thread the eyebolt
and nut removed
earlier into the
internally threaded
tube at the end of
the cable. Thread
engagement should
be about 3⁄4". Tighten
the nut against the tube at the end of the cable. See Figure 8.
Do not overtighten the clutch cable. Too much tension may cause it
NOTE:
to break. Be certain to check the clutch cable adjustment before operating
the tiller. See Clutch Cable under Adjustments in this section for cable
adjustment instructions.
Control Rod
1. Make sure the handle
assembly is in the
highest position.
Refer to the Controls
& Operation section.
1 1
2. Remove the cotter
pins from the control
rod, leave the rubber
washers on the
control rod. See
Figure 9.
5
Plastic Fitting
Internally
Threaded Tube
Figure 7
Machine Screw
Clutch
Flat Washer
Control
Threaded
Eyebolt
Nut
Internally
Threaded
Tube
Figure 8
Cotter Pin
Rubber
Washers
Cotter Pin
Figure 9
Flange
Lock
Nut