RIDGID R4110 Manual Del Operador página 17

ASSEMBLY
To Leave Your Mark:
Position the laser line near the right edge of your mark on
the work surface in order to leave the mark.
After you have become familiar with using the laser guide,
you will be able to remove, cut, or leave your mark on the
work surface. Practice will teach you the correct position for
aligning the laser line with your mark.
NOTE: Many of the illustrations in this manual show only
portions of the compound miter saw. This is intentional so
that we can clearly show points being made in the illustra-
tions. Never operate the saw without all guards securely
in place and in good operating condition.
SQUARING THE SAW BLADE TO THE FENCE
See Figures 15 - 20
 Unplug the saw.
 Pull the saw arm all the way down and engage the lock
pin to hold the saw arm in transport position.
 Loosen the miter lock knob approximately one-half turn.
 Depress the miter lock plate, and rotate the miter table
until the scale indicator is positioned at 0° and the control
arm is seated in the positive notch.
 Release the miter lock plate and securely tighten the miter
lock knob.
 Lay a framing square flat on the miter table. Place one
leg of the square against the fence. Slide the other leg
of the square against the flat part of saw blade.
NOTE: Make sure that the square contacts the flat part
of the saw blade, not the blade teeth.
 The edge of the square and the saw blade should be
parallel as shown in figure 16.
 If the front or back edge of the saw blade angles away
from the square as shown in figures 17 and 18, adjust-
ments are needed.
CAUTION:
To keep from losing control of the unit, steady the
base with one hand while loosening the two socket
head cap screws with the other hand.
 With the unit securely resting on a large stable surface,
tilt the unit by lifting up on one side of the base.
 Using a 5 mm hex key, loosen the two socket head cap
screws on the underside of the saw table.
 Return the saw to its normal resting position. Make sure
the miter lock knob is loose but do not release the miter
lock plate.
 Move the table so that the blade contacts the full length
of the framing square. Turn the miter lock knob clockwise
to lock saw square to the fence.
SOCKET HEAD
CAP SCREW
BOTTOM VIEW OF SAW
SLIDING
MITER
FENCE
MITER
TABLE
VIEW OF BLADE SQUARE WITH FENCE
BLADE
SLIDING
MITER
FENCE
VIEW OF BLADE NOT SQUARE WITH FENCE,
ADJUSTMENTS ARE REQUIRED
17
BLADE
FRAMING
SQUARE
LOCK KNOB
FRAMING
MITER
SQUARE
LOCK PLATE
MITER
TABLE
Fig. 15
MITER
Fig. 16
Fig. 17