RIDGID R4110 Manual Del Operador página 28

OPERATION
Bevel
Angle Type of Cut
Setting
Left side, inside corner
1. Top edge of molding against fence
0°
2. Miter table set right 45°
3. Save left end of cut
Right side, inside corner
1. Bottom edge of molding against fence
0°
2. Miter table set left 45°
3. Save left end of cut
Left side, outside corner
1. Bottom edge of molding against fence
0°
2. Miter table set left 45°
3. Save right end of cut
Right side, outside corner
1. Top edge of molding against fence
0°
2. Miter table set right 45°
3. Save right end of cut
CUTTING WARPED MATERIAL
See Figures 32 - 33.
When cutting warped material, always make sure it is posi-
tioned on the miter table with the convex side against the
fence as shown in figure 33.
If the warped material is positioned the wrong way as shown
in figure 32, it will pinch the blade near the completion of
the cut.
WARNING:
To avoid a kickback and to avoid serious personal
injury, never position the concave edge of bowed
or warped material against the fence.
28
5 5
0
WRONG
5 5
0
RIGHT
Fig. 32
Fig. 33