Descargar Imprimir esta página

Parkside PKSA 40-Li B2 Traduccion Del Manual De Instrucciones Originale página 47

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 225
Always switch off the device
and allow the motor to cool
before filling with chain oil.
There is a risk of fire if oil
overflows.
Removing/inserting the
rechargeable battery
1.­ To­insert­the­batteries­(16)­into­the­de-
vice,­push­the­batteries­along­the­guide­
rails­(23)­into­the­device.­You­will­hear­
them click into place.
2.­ To­remove­the­batteries­(16)­from­the­
device,­press­the­release­button­
16a)­on­the­batteries­and­pull­the­
(
batteries out.
Operating
Switch on the chainsaw only when
chain­bar,­saw­chain­and­sprocket­
chain wheel covering are correctly
assembled.
Make sure you have a secure
stance.­Before­starting,­ensure­that­
the electric chainsaw is in contact
with no objects.
­ Caution!­Saw­can­oil­up,­see­notes­
on Operation startup.
Switching on
The device may only be used with
two batteries of the Parkside
X 20 V­Team­series.
1. Place the batteries (
device (see "Inserting/removing the
rechargeable­battery").
2. Press the On/Off button (
16)­into­the­
26).­The­
LEDs­on­the­control­panel­light­up.
3.­ Check­before­the­start,­
-­ whether­sufficient­chain­oil­is­in­the­
tank­and,­if­necessary,­refill­with­
chain oil (see Chapter Operation
Start).
-
the charge level of the batteries.
4.­ Release­the­chain­brake,­where­you­
shift­the­brake­arm­(5)­back­against­the­
front­grip­(4).
5.­ Hold­the­chainsaw­firmly­with­both­
hands,­with­the­right­hand­on­the­rear­
grip­(1)­and­the­left­hand­on­the­front­
handle­(4).­Thumb­and­finger­must­
close securely over the handles.
6.­ To­start­the­device,­push­the­switch­lock­
3)­forwards­with­the­right­thumb­
(
and­press­the­on/off­switch­(2).­The­de-
vice will run at top speed. Release the
switch lock (
7. The power saw switches off when you
release­the­On/Off­switch­(2)­again.­
Switching for continuous running is not
possible.
Battery charge level
indicator
Press the On/Off button (
The­LEDs­on­the­control­panel­
light up.
high
low
high/low
The charge level of the batteries is indi-
cated by illumination of the corresponding
LED­lights­of­the­battery­charge­level­indi-
24).
cator (
3 LEDs illuminated (red, orange and green):
Battery charged
2 LEDs illuminated (red and orange):
Battery partially charged
1 LED illuminated (red):
Battery needs to be charged
GB
3).
IE
26).­
47

Publicidad

loading