Parkside PKSA 40-Li B2 Traduccion Del Manual De Instrucciones Originale página 55

Starting up a new saw chain
In­the­case­of­a­new­chain,­the­tensioning­
force­decreases­after­some­time.­Therefore,­
you have to re-tension the chain after the
first­5­cuts­and­no­later­than­after­10­min-
utes' sawing time.
never attach a new chain to
a worn drive pinion or place
onto a damaged or worn
chain bar. The chain could
spring back or break, poten-
tially leading to serious injury.
Maintaining the chain bar
Use cut-protection gloves
when handling the chain or
the chain bar.
1. Switch off the device and remove the
16)­before­carrying­out­
battery (
any maintenance work.
2. Remove the sprocket chain wheel cov-
13),­the­saw­chain­(
ering (
and the chain bar (
3. Check the chain bar (
Remove burrs and straighten the guide
surfaces­with­a­flat­file.
4. Clean the oil passages (
the­chain­bar,­in­order­to­guarantee­a­
trouble-free,­automatic­oiling­of­the­saw­
chain during operation.
5. Mount chain bar (
6)­and­sprocket­chain­wheel­cover-
(
13)­and­tighten­the­chainsaw.
ing (
With the oil nozzles in good condi-
tion and the oil regulator set cor-
rectly,­the­saw­chain­will­spray­a­
little oil off after starting.
6)­
7).
7)­for­wear.­
28),­of­
7),­chainsaw­
Turn the chain bar
Use cut-protection gloves when han-
dling the chain or the chain bar.
The­blade­(7)­has­to­be­reversed­regularly­
after a working time of approximately 10
hours in order to ensure even wear.
1. Switch off the device and remove the
16)­before­carrying­out­
battery (
any maintenance work.
2. Remove the sprocket chain wheel cov-
ering­(13),­the­saw­chain­(6)­and­the­
chain­bar­(7).
3. Turn the blade around its horizontal
axis and install the blade and chain as
described under "Installing the sawing
chain and blade".
­ When­doing­so,­pay­attention­to­the­
correct rotation direction of the saw
chain!
Use the graphical symbol below the chain
sprocket­(20)­as­a­guide­to­the­alignment­
of­the­saw­chain­(6)­when­the­blade­is­ro-
tated. The illustrated direction of travel on
the blade is no longer true.
Storage
•­ Clean­the­equipment­before­putting­it­
away.
•­ Empty­the­oil­tank­before­longer­peri-
ods of non-use. Dispose of waste oil
environmentally correctly (see „Waste
disposal and environmental protec-
tion").
•­ Put­on­saw­bar­protection­sheath.
•­ Store­the­appliance­in­a­dry­place­well­
out of reach of children
GB
Direction of travel of the
saw chain
IE
55