AEG IPE84571IB Manual De Instrucciones página 84

Incorrect cookware position:
6.5 PowerSlide
This function allows you to adjust the
temperature by moving the cookware to a
different position on the induction cooking
area.
The function divides the induction cooking
area into three areas with different heat
settings. The hob detects the position of the
cookware and adjust the heat setting
corresponding with the position. You can
place the cookware in the front, middle or
rear position. If you place the cookware in the
front you get the highest heat setting. To
decrease it, move the cookware to middle or
rear position.
84 ENGLISH
Use only one pot when you operate the
function.
If you want to change the heat setting, lift
up the cookware and place it on a
different zone. Sliding the cookware can
cause scratches and discolouration of the
surface.
• 160 mm is the minimum bottom diameter
of the cookware for this function.
• If you place the pot in the front position,
lights up on the control panel. The control
bar displays the default heat setting
• If you place the pot in the middle position,
lights up on the control panel. The
control bar displays the default heat
setting .
• If you place the pot in the rear position,
lights up on the control panel. The control
bar displays the default heat setting
• To change the default heat setting use left
front control bar. You may change the
default heat setting only if the function is
active. You can change the heat settings
for each position separately. The hob will
remember your settings next time you
activate the function.
Touch to activate the function.
The indicator comes on and the control bar
displays the default heat setting.
To deactivate the function, touch
.
.
.