Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY INSTRUCTIONS
ELECTRICAL:
1. This unit must be connected to a supply circuit that is protected by a ground-fault-circuit-interrupter (GFCI). Such a GFCI should be provided by the
installer and should be tested on a routine basis. To test the GFCI, push the test button. The GFCI should interrupt power. Push the reset button.
Power should be restored. If the GFCI fails to operate in this manner, there is a ground current flowing indicating the possibility of an electric shock.
Do not use this unit. Disconnect the unit and have the problem corrected by a qualified service representative before using.
2. Disconnect power before servicing.
3. Whirlpool Pump Connections Only:
3.1. A green colored terminal (or wire connector marked "G", "GR", "Ground" or "Grounding") is provided within the terminal compartment. To reduce
the risk of electric shock, connect this terminal or connector to the grounding terminal of your electric service or supply panel with a continuous
green insulated copper wire equivalent in size to the circuit conductors supplying this equipment.
3.2. A pressure ground connector is provided on the exterior of the terminal box within this unit to permit connection of a No. 8 AWG (8.4mm²) solid
copper bonding conductor between this unit and all other electrical equipment and exposed metal in the vicinity, as needed to comply with state
and local requirements.
4. Install to permit access for servicing (for built-in and custom units).
5. Installer / Owner bears all responsibility to comply with all state and local codes when installing this product.
INSTALL YOUR FAUCET KIT
1. Find your faucet kit
Obtain the faucet kit and 1/2" water inlet pipes at the location shown below and unpack it.
Check for broken or missing faucet kit.
Additional information can be found in the TWO HANDLE ROMAN FAUCET manual.
Follow the assembly instructions from the manual.
If you have any questions, please read the TWO HANDLE ROMAN FAUCET manual.
2. The openings required for the Faucet kit are factory done on the bathtub. Please refer to
the diagram to determine the location of the accessories to be installed.
6
1
9
2
Publicidad
