Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALL YOUR FAUCET KIT
6. Unscrew the set screws from the handle assemblies and remove the handle assemblies
from the valve bodys. Loosen the nuts from the valve bodys. Adjust the washers and
mounting nuts to the bottom of valve bodies.
7. From underneath the deck, insert the valve body with the rubber washer, metal washer
and mounting nut through hole on the right (cold) side. From above, thread the nut onto
valve body. Tighten the mounting nut, so that the nut sits flush to the surface of working
area. Then insert the other valve body through holes on the left (hot) side and install in
the same way.
Note: The hot valve is labeled.
8. Place the handle assembly onto the right (cold) valve. Then thread the handle seat onto
the nut. Place the set screw into handle assembly and tighten set screw with Allen
wrench (Hex: 2.5mm, 1), Place the other handle assembly onto the left (hot) valve and
install the same way.
8
6
7
8
Publicidad
