Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALL YOUR FAUCET KIT
3. Remove the plastic cap and connector from the middle body. Adjust the
washers and mounting nut to the bottom of middle body.
4. From underneath the deck, insert the middle body with the rubber washer,
metal washer and mounting nut through hole. From above, thread the
connector onto middle body. Tighten the mounting nut, so that the connector
sits flush to the surface of working area. Note: The middle body must turn to
the direction as shown in the diagram.
Note: The middle body must turn to the direction as shown in the diagram.
5. Place the spout assembly onto the connector. Be sure the spout assembly is
resting firmly on the deck. Push down on spout assembly and tighten set
screw with Allen wrench (Hex: 3.2mm, 1). Insert the cap.
Thread the lift rod onto diverter body through the spout assembly tightly.
7
3
4
5
Publicidad
