Publicidad
Idiomas disponibles
Idiomas disponibles
PROBLEM
Engine will not start.
Engine hard to start.
Electric start feature not work-
ing.
Engine lacks power.
AC receptacle does not work.
Generator makes a "spark
knock" or "pinging" noise.
MAXCONTROL
LCD display
™
is not working.
If problem persists after trying the above solutions, contact customer service or a qualified service center for assistance.
NOTICE:
As the equipment owner, you are responsible for the performance of the required maintenance listed in the Maintenance sec-
tion. It is recommended that you retain all receipts covering maintenance on your equipment. Neglecting or failing to perform
the required maintenance may increase emissions, decrease fuel efficiency, degrade performance, cause irreversible engine
damage and/or void your warranty.
TROUBLESHOOTING
POSSIBLE CAUSE
On/off switch is OFF (O).
No fuel.
Stale gasoline or water in gasoline.
Lubricant level is low.
Fuel valve is OFF (O).
Spark plug faulty, fouled, or improperly gapped.
Choke is in RUN position.
Engine stored without treating or draining gasoline,
or refueled with bad gasoline.
Dirty fuel filter.
Water in gasoline.
Weak spark at spark plug.
On/off switch is in OFF (O) position.
MAXCONTROL
LCD display is in sleep mode.
™
Battery wires are disconnected.
Battery is not charged.
Engine battery charge circuit fuse is blown.
Dirty air filter.
Engine stored without treating or draining gasoline,
or refueled with bad gasoline.
Circuit breaker is tripped.
GFCI is tripped.
Item plugged in is defective.
An occasional light "knocking" or "pinging" under
heavy load is not a cause for concern. However, if
the knocking or pinging occurs under normal load
at a steady engine speed, the problem may be with
the brand of gasoline being used.
Battery cables are not connected.
Display is in sleep model.
Battery charge is very low.
Page 20 — English
SOLUTION
Turn on/off switch to ON (I).
Fill fuel tank.
Drain entire system and refill with fresh fuel.
Engine is equipped with Low Oil Shutoff. If engine
lubricant level is low, it must be filled before unit
will start. Check engine lubricant level and fill, if
necessary.
Turn fuel valve ON (I).
Replace spark plug.
Pull the choke lever out to the START position.
Drain fuel and carburetor. Refuel with fresh gasoline.
Replace fuel filter or contact a qualified service
center
Drain entire system and refill with fresh fuel.
Replace spark plug or contact a qualified service
center.
Turn the on/off switch ON ( l ).
Press and release the pairing button or toggle the
on/off switch off and on to wake the display.
Connect the battery wires.
Charge the battery.
Replace the engine battery charge circuit fuse.
Check air filter element. Clean or replace as needed.
Drain fuel and carburetor. Refuel with fresh gasoline.
If problem continues, contact a qualified service
center.
Reset the AC circuit breaker.
Reset the GFCI.
Try a different item.
Switch to a different brand of gasoline, making sure
that the octane rating is 86 or higher. If problem
continues, contact a qualified service center.
Connect the battery.
Press and release the pairing button or toggle the
on/off switch off and on to wake the display.
Recharge the battery.
Publicidad
