Opening The Housing - OHAUS T21P Manual De Instrucciones

EN-6
2.2.5 Mounting Column Bracket
The Indicator can be mounted to a scale column of 38mm outside diameter with the
supplied column bracket.
1. Route the cable through the column and the column bracket.
2. Slide the column bracket down onto the column and tighten the nut.
3. Solder the load cell cable to supplied load cell cable connector (see section
2.2.1).
4. Slide the indicator onto the bracket as shown below.
5. Plug the load cell cable into the indicator load cell connector Figure 1-1,
Item 10.
6. Remove the upper knob to change the viewing angle, re-install the knob to
fix the position.

2.3 Opening the Housing

CAUTION: ELECTRICAL SHOCK HAZARD. REMOVE ALL POWER
CONNECTIONS TO THE INDICATOR BEFORE SERVICING OR MAKING
INTERNAL CONNECTIONS. THE HOUSING SHOULD ONLY BE OPENED
BY AUTHORIZED AND QUALIFIED PERSONNEL, SUCH AS AN ELECTRICAL
TECHNICIAN.
2.4 Initial Setup and Calibration
Once properly assembled and powered up, set up the scale parameters (Section 4)
and calibrate (Section 5).
3
1
2
5
4
T21P Indicator