AEG HK854080XB Manual De Instrucciones página 12

12 www.aeg.com
7. TROUBLESHOOTING
You cannot activate or
operate the appliance.
An acoustic signal
sounds and the appli-
ance deactivates.
An acoustic signal
sounds when the appli-
ance is deactivated.
The appliance deacti-
vates.
The residual heat indica-
tor does not come on.
The Automatic Heat Up
function does not oper-
ate.
You cannot activate the
outer ring.
The sensor fields be-
come hot.
There is no acoustic sig-
nal when you touch the
panel sensor fields.
Problem Possible cause
The appliance is not
connected to an electri-
cal supply or it is con-
nected incorrectly.
You touched 2 or more
sensor fields at the same
time.
The STOP+GO function
operates.
There is water or fat
stains on the control
panel.
You put something on
one or more sensor
fields.
You put something on
the sensor field
The cooking zone is not
hot because it operated
only for a short time.
The cooking zone is hot. Let the cooking zone be-
The highest heat setting
is set.
The cookware is too
large or you put it too
near to the controls.
The signals are deactiva-
ted.
Remedy
Check if the appliance is
correctly connected to
the electrical supply (refer
to connection diagram).
Activate the appliance
again and set the heat
setting in less than 10
seconds.
Touch only one sensor
field.
Refer to the chapter "Dai-
ly Use".
Clean the control panel.
Remove the object from
the sensor fields.
Remove the object from
the sensor field.
.
If the cooking zone oper-
ated sufficiently long to
be hot, speak to the serv-
ice centre.
come sufficiently cool.
The highest heat setting
has the same power as
the Automatic Heat Up
function.
Activate the inner ring
first.
Put large cookware on
the rear cooking zones if
necessary.
Activate the signals (refer
to "OffSound Control").