AEG HK854080XB Manual De Instrucciones página 8

www.aeg.com
8
acoustic signal sound some time and
the appliance deactivates. Remove the
object or clean the control panel.
• You do not deactivate a cooking zone
or change the heat setting. After some
time
deactivates. See below.
• The relation between heat setting and
times of the Automatic Switch Off
function:
•
,
•
-
•
-
•
4.3 The heat setting
Touch the control bar at the heat set-
ting. Move your finger along the control
bar to change the setting. Do not re-
lease before you have a correct heat set-
ting. The display shows the heat setting.
4.4 Activation and
deactivation of the outer rings
You can adjust the surface you cook to
the dimension of the cookware.
To activate the outer ring touch the sen-
sor field
comes on. For more outer rings touch
the same sensor field again. The subse-
quent indicator comes on.
Do the procedure again to deactivate
the outer ring. The indicator goes out.
4.5 Automatic Heat Up
You can get a necessary heat setting in a
shorter time if you activate the Automat-
ic Heat Up function. This function sets
the highest heat setting for some time
(see the diagram), and then decreases to
the necessary heat setting.
To start the Automatic Heat Up function
for a cooking zone:
1.
Touch
play).
comes on and the appliance
- — 6 hours
— 5 hours
— 4 hours
- — 1.5 hours
/ / . The indicator
( comes on in the dis-
2. Immediately touch the necessary
heat setting. After 3 seconds
comes on in the display.
To stop the function change the heat
setting.
12
11
10
9
8
7
6
5
4
3
2
1
0
1 2 3 4 5 6 7 8 9 10 11 12 13 14
4.6 Timer
Count Down Timer
Use the Count Down Timer to set how
long the cooking zone operates for only
this one time.
Set the Count Down Timer after the
selection of the cooking zone.
You can set the heat setting before or af-
ter you set the timer.
• To set the cooking zone: touch
again and again until the indicator of a
necessary cooking zone comes on.
• To activate the Count Down Timer:
touch of the timer to set the time (
00 99
- minutes). When the indicator
of the cooking zone start to flash slow,
the time counts down.
• To see the remaining time: set the
cooking zone with
of the cooking zone starts to flash
quickly. The display shows the remain-
ing time.
• To change the Count Down Timer:
set the cooking zone with
or .
• To deactivate the timer: set the
cooking zone with
remaining time counts back to
The indicator of the cooking zone
goes out. To deactivate you can also
touch and
. The indicator
. Touch
. Touch . The
00
.
at the same time.