Publicidad
Idiomas disponibles
Idiomas disponibles
USE OF THE MACHINE
The manufacturer will not be held responsi-
ble for damages deriving from:
• Improper use or for purposes other than those
indicated in this manual.
• Repairs carried out by unqualified personnel,
other than authorized dealer.
• Tampering with power cord.
• Tampering with any component.
• Installation of non-original spare parts and
accessories.
• Negligence in maintenance, cleaning or des-
caling.
• Storage in areas with room temperature below
0°C.
• Usage of capsules other than Essse Sistema
Espresso.
In these cases, the warranty is invalidated.
UNPACKING AND SETUP
Remove the machine from its package and
check that all components are present and
not broken. The packaging components must
be handled carefully due to sharp edges.
Place the machine on a flat, stable surface,
far from water, flames and heat sources.
When in operation, the machine must not be
covered by tea towels or anything else.
1
Raise the tank cover and extract the tank itself. If
furnished, insert the anti-calc filter, following the
instructions found with the filter.
2
Fill the water tank to the MAX level with fresh
clean drinking water. To do so, lift the water tank
cover and fill the tank directly.
Check that the ON/OFF switch is on the OFF
position.
The water level must not exceed MAX. Only use fresh, clean drinking water. Hot water
or any other liquid may damage the tank. Do not operate the machine without water.
21
Plug
3
fied the voltage stamped on the technical
data plate on the bottom of the machine.
4
Turn the ON/OFF switch to ON. Button 1 will
light up a steady amber color. Press button
1 to exit the energy saving mode and begin
the pre-heating phase, during which buttons
1/2/3 will be blinking blue. When buttons
1/2/3 show a steady blue color, the machine
is ready to use.
At the time of first use, or after a long period
of non-use, or when the water tank is empty,
it is necessary to replenish the water supply
by carrying out the operation described be-
low. This operation also renews the residual
water present within the hydraulic circuit.
1
Check that the water tank is full and correctly
positioned.
2
Place a cup on the cup grid and open the cap-
sule insertion sliding board. Insert an Essse Siste-
ma Espresso capsule into the capsule insertion
compartment and close the sliding board.
3
Start up the automatic cycle by pressing the long
shot button; wait for water to emerge from the
brewing spout.
1
After 10 minutes of inactivity (default), the ma-
chine goes into energy saving mode. Button 1
shows a steady amber color.
2
To suspend the energy saving mode, press but-
ton 1 to cause the machine to enter the pre-heat-
ing phase.
Buttons 1/2/3 will blink blue.
Buttons 1/2/3 show steady blue color: this sig-
nals that the machine is ready for use.
Espresso and hot drink machine which uses single-dose capsules
in
the
machine
after
START-UP
ENERGY SAVING
EN
having
veri-
Publicidad
