Publicidad
Idiomas disponibles
Idiomas disponibles
7.
Install the hanger assembly onto the upright support bracket using a
carriage bolt (710-0276) and wing knob (720-04122) from hardware pack
689-00312. See Figure 9.
Assembling Remaining Bagger Components
Now that the mounting brackets are assembled and are in place on the tractor,
follow these steps to assemble the remaining bagger components.
1.
Snap the plastic upper chute support in place by first clipping the side
portion onto the bag support rail with the edge of the snap feature aligned
with the red line (1), as shown in the inset of Figure 10.
2.
Snap the front portion of the upper chute support to the bag support rail as
seen in 2 of Figure 10.
2
ASSEMBLY AND INSTALLATION
Figure 9
Figure 10
3.
Install the grass catcher cover onto the bag support assembly, as seen in
Figure 11. The grass catcher cover goes inside of the two mounting tabs on
the bag support assembly.
4.
Slide the hinge pin into the hole located on the mounting tab, as in Figure
12. Use the cut-out window (See inset in Figure 12) to line up the hinge pin
on the other side and push pin all the way in until it reaches the end-stop. At
this point the pin clips into place and is secured by a tab in the bagger cover.
See Figure 13.
1
10
Figure 11
Figure 12
Publicidad
