Publicidad
Idiomas disponibles
Idiomas disponibles
Mount Assembly on Tractor
Install the mounting assembly on the tractor as follows:
1.
Place the hooked ends of the bagger mounting assembly over the shoulder
bolts on the mounting brackets previously installed on the tractor in Figure 1.
2.
Install the two clevis pins (711-0332) and secure to the mounting brackets
with two click pins (914-0145) included with the mounting bracket kit.
3.
Install the clevis pin (711-0309A) from hardware pack 689-00312 into the tractor's
hitch and the assembly's hitch support and secure with a hairpin clip (714-0117).
See Figure 6.
Note: The clevis pin can be fed down through the hitch support and secured
underneath with the hairpin clip, or it may be easier to feed the clevis pin up
through the hitch plate hole and secure with the hairpin clip on the topside.
4.
Tighten all of the hardware on the mounting bracket assembly and hitch
support at this time.
ASSEMBLY AND INSTALLATION
Figure 5
Align hole on bracket
with hole on tractor
Figure 6
5.
Install the upright support bracket onto the mounting assembly on the
tractor by hooking it over the cross mounting bracket and aligning it with
the mounting hole indicating the deck size your machine is equipped with,
as shown in Figure 7.
Note: The mounting bracket includes a stamping above each mounting hole
indicating which position to mount the upright bracket. See the inset of
Figure 7.
6.
Secure the bag support assembly to the mounting assembly using a carriage
bolt (710-0276) and wing knob (720-04122) from hardware pack 689-00312.
9
Figure 7
Figure 8
Publicidad
