Publicidad
Idiomas disponibles
Idiomas disponibles
FR
ES
PT
IT
Suction hose
Assemble the different elements together according to the illustration. In case screw are necessary : tight
EL
it with appropriate tool.
• As a basic principle, we recommend using a suction-hose set with suction hose and an check valve with
a strainer (in order to prevent long priming periods).
PL
• If you cannot obtain a suction-hose set, please purchase :
- a 25 mm (1") intake hose
- a check valve with a strainer
RU
- 2 hose clamps 2 standard adapters (one for the suction hose, one for the discharge line) and assemble
the suction-hose set yourself using a standard adapter and a clamp.
KZ
4.3 FIRST USE
UA
RO
Pay particular attention using the machine for the first time : focus and dedicate all your attention to this
EN
first use.
Setting up your pump
• Place the pump on flat firm surface to ensure safe operation.
• Remove the connectors caps from the connectors and store them.
Connecting the suction hose
• Screw the standard connectors onto the suction connector.
• Assemble the suction hose using a standard connector and clamp. Make sure the assembly is tight
enough as a leaking suction hose will draw in air instead of water.
• Position the suction hose so that it rises from the water withdrawal point to the pump. Avoid positioning
the suction hose higher than the pump, as this would delay the escape of air bubbles and impede the
priming process.
• The end of the check valve should be low enough in the water to ensure that if the water level falls, the
pump will not run dry.
• A leaking suction hose will draw in air instead of water. Please make sure the clamp is properly tightened.
• For suction heights exceeding 3 m we recommend securing the suction-hose (e.g. by fastening it to a
wooden post). This relieves the pump of the weight of the suction hose.
DANGER! Risk of injury due to electric shock.
Warning! Do not plug in before installation is fully completed !
CAUTION ! Always wear safety glasses and gloves during
installation.
illustration 2.2
WARNING ! Read the « SAFETY INSTRUCTION » section at the
beginning of this manual including all text under subheading
therein before using this product.
Illustration 2.1
Illustration 2.2 to 3.2
Risk of damage to the pump!
The hose adapters on the suction and discharge connectors
must only be tightened by hand to avoid damage to
connectors. If water leaking at the connector, seal the joint
with Teflon tape (not included).
206
11
R
K
U
R
E
Publicidad
