Publicidad
Idiomas disponibles
Idiomas disponibles
R
• Install the intake and discharge lines in such a way that they do not place the pump under any
mechanical strain.
Priming the pump
S
First, unscrew the filter cap to remove air from the pump during filling.
Fill the pump with clear water via discharge connector. Filling must be done slowly so that the air
T
contained in the pump is completely expelled. Fill to overflow and put back the filling plug. As this is
not an auto-priming pump, the suction pipe will also need to be filled. To save time when filling, you
can detach the suction pipe set and fill it directly (by submerging the suction pipe in water, for example)
T
before connecting the pump.
Depending on the suction height and the amount of air in the suction hose, priming can take anywhere
L
between 1 minute to 5 minutes. If it takes longer than this, the pump should be refilled with water.
Illustration 4.2
Always remove the plug from the socket before refilling !
L
Connecting the discharge hose
For automatism and discharge hose installation, please refer to the illustration.
U
A hose with a diameter of 25mm is recommended for better results.
4.4 OPERATION
Z
Start the pump
Make sure the pump is correctly installed and primed, refer to chapter "first use" above.
A
Connect the power cable to an earthed 220-240V 50Hz power supply protected by a minimum 10-amp
fuse. Press the reset button.
Operation safety warnings
O
• Operate the product only at reasonable hours – not early in the morning or late at night
N
when people might be disturbed.
• Do not modify the product in any way or use parts and accessories that are not
recommended by the manufacturer.
Operate the pump
• In order to prevent dry-running and overheating of the machine, always make sure that the suction
hose is immersed under water.
• The motor is protected against overheating by an integrated thermostat. In the event of overheating,
the thermostat will automatically switch off the pump. The pump will automatically restart after it has
cooled down.
Stop the pump
• To reduce the risk of injury, always stop the machine :
- before cleaning or clearing a blockage
- before installing or removing attachments
illustration 3.1 to 4.2
illustration 3.5
If the product is dropped, suffers heavy impact or begins to
vibrate abnormally, immediately stop the product and
inspect for damage or identify the cause of the vibration. Any
damage should be properly repaired or replace by an
authorized service center.
207
12
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
EN
Publicidad
