Sauder Briarbrook Serie Instrucciones De Montaje página 10

Step 4
å
1 - Push four HIDDEN CAMS (7) into the RIGHT UPRIGHT (E) and RIGHT END (F).
st
å
2 - Separate two LONG EXTENSION SLIDES (2) from two LONG EXTENSION RAILS (1) as
nd
shown in the upper diagram below. Be prepared, the parts are greasy.
å
3 - Fasten two LONG EXTENSION RAILS (1) to the RIGHT UPRIGHT (E) and RIGHT END (F)
rd
as shown. Use six BLACK 1/2" FLAT HEAD SCREWS (23).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged
diagram. Then, slide the inner cartridge of the EXTENSION RAIL in to find the other holes that
line up with the holes in the UPRIGHT and END. Turn a SCREW into these holes.
å
NOTE: The LONG EXTENSION SLIDES will be used later for the LARGE DRAWERS.
2
nd
Push the black lever and pull the SLIDE from the RAIL.
1
st
Arrow
7
Page 10
2
BLACK 1/2" FLAT HEAD SCREW
(6 used in this step)
E
1
3
rd
The notch
must be here.
www.sauder.com/service
23
F
1
3
rd
7
1
Use these holes.
1
st
7
Open end
Arrow
430072