Sauder Briarbrook Serie Instrucciones De Montaje página 17

Step 11
å
Fasten the END FRAMES (W and Z) to the BOTTOM
BRACE (X). Tighten four 1/2" HEX HEAD SCREWS using
the L-WRENCH (16).
å
NOTE: You should start each SCREW a few turns before
completely tightening any of them.
å
Peel the FELT PADS from the FELT PAD CARD (13). Stick
a FELT PAD onto each corner of each END.
1/2" HEX HEAD SCREW
(4 used in this step)
430072
13
W
24
16
www.sauder.com/service
X
These holes must be here.
Z
Page 17