Sauder Briarbrook Serie Instrucciones De Montaje página 18

Step 12
å
NOTE: In this step, you may want to start each SCREW a few turns before
completely tightening any of them.
å
Fasten the END FRAMES (W and Z) to the TOP (A) and ENDS (C and F).
Tighten ten 1/2" HEX HEAD SCREWS (24) using the L-WRENCH (16).
å
Fasten the END FRAMES (W and Z) to the BOTTOMS (B). Tighten four
1-7/8" HEX HEAD SCREWS (17) using the L-WRENCH (16).
å
Fasten the END FRAMES (W and Z) to the TOP BRACE (Y). Tighten two
1-3/16" HEX HEAD SCREWS (19) using the L-WRENCH (16).
1-7/8" HEX HEAD SCREW
(4 used for the BOTTOMS)
1/2" HEX HEAD SCREW
(10 used for the TOP and ENDS)
Page 18
17
W
F
24
www.sauder.com/service
B
A
Y
1-3/16" HEX HEAD SCREW
(2 used for the BRACE)
16
Z
B
C
19
430072