Sauder Briarbrook Serie Instrucciones De Montaje página 14

Step 8
å
1 - Push four HIDDEN CAMS (7) into the LEFT END (C) and LEFT UPRIGHT (D).
st
å
2 - Separate two LONG EXTENSION SLIDES (2) from two LONG EXTENSION RAILS (1) as
nd
shown in the upper diagram below. Be prepared, the parts are greasy.
å
3 - Fasten two LONG EXTENSION RAILS (1) to the LEFT END (C) and LEFT UPRIGHT (D) as
rd
shown. Use six BLACK 1/2" FLAT HEAD SCREWS (23).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged
diagram. Then, slide the inner cartridge of the EXTENSION RAIL in to find the other holes that
line up with the holes in the END and UPRIGHT. Turn a SCREW into these holes.
å
NOTE: The LONG EXTENSION SLIDES will be used later for the LARGE DRAWERS.
2
nd
Push the black lever and pull the SLIDE from the RAIL.
1
st
Arrow
7
Page 14
2
BLACK 1/2" FLAT HEAD SCREW
(6 used in this step)
C
1
3
rd
www.sauder.com/service
23
D
1
3
rd
7
1
Use these holes.
1
st
7
The notch
must be here.
Open end
Arrow
430072