Sauder Briarbrook Serie Instrucciones De Montaje página 13

Step 7
å
1 - Separate three SHORT EXTENSION SLIDES (4) from three SHORT EXTENSION RAILS (3) as shown in the
st
upper diagram below. Be prepared, the parts are greasy.
å
2 - Fasten one SHORT EXTENSION RAIL (3) to the surface of the LEFT UPRIGHT (D) as shown. Use three
nd
BLACK 1/2" FLAT HEAD SCREWS (23).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the
inner cartridge of the EXTENSION RAIL in to find the other holes that line up with the holes in the UPRIGHT.
Turn a SCREW into these holes.
å
NOTE: The SHORT EXTENSION SLIDES will be used later for the SMALL DRAWERS and KEYBOARD SHELF.
å
3 - Carefully flip the LEFT UPRIGHT (D) over.
rd
å
4 - Fasten two SHORT EXTENSION RAILS (3) to the LEFT END (C) and LEFT UPRIGHT (D) as shown. Use six
th
BLACK 1/2" FLAT HEAD SCREWS (23).
1
st
Push the black lever and pull the SLIDE from the RAIL.
This hole
must be here.
4
th
430072
4
BLACK 1/2" FLAT HEAD SCREW
(9 used in this step)
This hole
must be here.
4
th
D
C
3
Open end
www.sauder.com/service
23
3
rd
3
Open end
7
3
Use these holes.
2
nd
D
3
Open end
The notch
must be here.
Page 13