Clatronic KM 3674 Instrucciones De Servicio página 59

Timer (Electronic)
With the buttons and / , you can determine when the
process should end.
Time maximum: 9 minutes and 59 seconds.
1. Press the button once.
You can set the minutes with the buttons / .
2. Press the button again.
You can set the seconds with the buttons / .
• If you want to delete your time input again, press the
buttons and simultaneously.
• When the appliance starts, the remaining time is dis-
played. The countdown runs.
Interrupt Process
• Turn the rotary knob anticlockwise until the display shows
" ". The timer is stopped.
• The timer continues to count down if the appliance is
started again within 5 minutes.
Turning the Appliance Off
You can end every process ahead of time.
1. Turn the rotary knob anticlockwise until the display shows
" ".
2. Disconnect the mains plug from the socket.
The Kneading Machine
Installation and Operation of the Kneading Machine
CAUTION:
• Never press the release button (10), if you have placed
the mixing bowl! The mixing bowl tilts.
Never use the kneading machine with the mixing
•
vessel attached!
NOTE:
A safety switch prevents operation without cover for the
mixing engine.
Unless you have previously used the mixer or meat grinder,
cover the drive shaft of the mixing engine and the spiral
housing with the respective safety cover.
Table of Dough and Tools
Doughs
Heavy doughs (e. g. bread or short pastry)
Moderate doughs (e.g. cake mix)
Light doughs (e. g. waffle or crêpe batter, pudding)
Cream
Beaten egg whites
KM3674_IM
1. Open the swivel arm: Press the release button (10).
Move the arm by hand to the highest position.
2. If you need the splash guard, attach it now to the swivel
arm from below. Hold the splash guard (14) in such a
way that the fill opening is positioned in front of you. On
the bottom of the swivel arm, there are two recesses on
the front and back. Insert the splash guard with its guide
lugs into these recesses. Turn the splash guard towards
LOCK to lock it.
3. If you want to use the dough hook (19) or mixing hook
(18), first attach the hook splash guard (20). It will prevent
the drive shaft from getting in contact with the dough.
Hold the guard like a bowl. Insert the dough hook or the
mixing hook from below through the recess of the guard
and then lock it by turning it one quarter of a turn.
4. Attaching accessories:
On the top end of the accessories,
there is a recess for the drive shaft
and the splint. Slide the accessory
over the drive shaft. Push down
and at the same time turn the ac-
cessory anticlockwise in order for the splint of the drive
shaft to lock into the accessory.
5. Mixing bowl: Place the mixing bowl into its holder. Turn
the bowl towards
6. Fill your ingredients into the mixing bowl.
NOTE:
If you knead heavy doughs, do not put all the ingredi-
ents at once into the mixing bowl. Start the kneading
with flour, sugar and eggs. Add fluids slowly during the
kneading.
7. Press the release button (10) to lower the arm. You now
need to press on the arm from above until it snaps into
the lowest position.
8. Plug the power cord into an approved mains socket.
9. If you would like to work with the timer, set the operating
time.
10. Select a speed using the following table.
Tool Levels
Dough hook 1 - 3 max. 1.5 kg
min. 0.5 kg
Stirring hook 3 - 4
max. 3.5 kg
min. 500 ml
Whisk 4 - 5
max. 3.5 litre
min. 200 ml
Whisk 10
max. 1 litre
Whisk 10 4 -10 egg white
LOCK to its limit.
Quantity Max. Operating Time
3 - 4 minutes
2 - 4 minutes
2 - 4 minutes
3 - 5 minutes
3 - 5 minutes
22.06.17
59