Selco Genesis 2700 PMC Instrucciones De Uso página 48

Passing one of the warning limits causes a visual signal to appear
on the control panel.
Passing one of the alarm limits causes a visual signal to appear
on the control panel and the immediate blockage of the weld-
ing operations.
It is possible to set start and end of welding filters to prevent
error signals during the striking and extinction of the arc (consult
the "Set up" section - Parameters 802-803-804).
3.13 Alarms screen
Allows the intervention of an alarm to be indicated and provides
the most important indications for the solution of any problem
encountered.
1 Alarm icon
2 Alarm code
3 Alarm type
Alarm codes
E01, E02 Temperature alarm
It is advisable not to switch off the equipment while the alarm
is on; the internal fan will thus keep operating and will help to
cool the overheated parts.
E07 Wire feed motor supply alarm
E08 Blocked motor alarm
E10 Power module alarm
E13 Communication alarm
48
E19 System configuration alarm
E20 Memory fault alarm
E21 Data loss alarm
E40 System power supply alarm
E43 Coolant shortage alarm
Guard limits code
E54 Current level exceeded (Alarm)
E62 Current level exceeded (Warning)
E55 Current level exceeded (Alarm)
E63 Current level exceeded (Warning)
E56 Voltage level exceeded (Alarm)
E64 Voltage level exceeded (Warning)
E57 Voltage level exceeded (Alarm)
E65 Voltage level exceeded (Warning)
E74 Motor 1 current level exceeded (Warning)