Publicidad
Idiomas disponibles
Idiomas disponibles
Motor Specifications and Electrical Requirements
Power Supply and Motor Specifications
The A-C motor used on this tool is a universal non-revers-
ible type, having the following specifications:
General Electrical Connections
DANGER: To reduce the risk of electrocution:
1. Use only identical replacement parts when ser-
vicing. Servicing should be performed by a
qualified service technician.
2. Do not use in rain or where floor is wet.
This tool is intended for indoor residential use
only.
220 Volt, 50 Hz. Tool Information
WARNING: Saw is factory wired for 220V opera-
tion. Connect to 220V, 10-AMP branch circuit and
use 10-AMP time delay fuse or circuit breaker. Fail-
ure to connect in this way could result in injury
from shock or fire.
WARNING: If electrical shock occurs, your reaction
to shock could bring hands into contact with
blade.
WARNING: To avoid electric shock or fire, immedi-
ately replace worn, cut, or damaged power cord.
WARNING: Double insulation does not take the
place of normal safety precautions when operating
this tool.
Max Developed H.P.
Voltage
Amperes
Hertz (Cycles)
Phase
RPM
Shaft Rotation
Brake
WARNING Do not permit fingers to touch the termi-
nals of plug when installing or removing the plug
to or from the outlet.
NOTE: If saw does not start when switched on, immedi-
ately turn saw off and refer to Troubleshooting. Leaving
the switch on will destroy the motor.
The unit is wired for 220V and has a plug that looks like
this:
10 Amp Plug
43
3.0
220
7.5
50
Single
4000
Clockwise
Automatic
2 Prong
2 Prong
10 Amp Outlet
Publicidad
