Parkside PDSA 20-Li B2 Manual De Instrucciones página 38

GB MT
Starting spraying
1.­ Press­the­trigger­lever­(2)­on­the­pistol­
grip­(1)­to­spray.
Stopping spraying
2.­ The­spray­jet­stops­once­you­let­go­of­
the­trigger­lever­(2).
Secure­the­trigger­lever­(2)­against­
unintentional­operation­by­folding­
out­the­small­lever­on­the­trigger­lever­(2)­
and­placing­it­against­the­black­trigger­
gun (1).
Continuous operation
1.­ Press­the­trigger­lever­(2)­against­the­
trigger gun (1).
2.­ Push­the­small­lever­on­the­trigger­lever­
(2)­forward­to­lock­the­trigger­lever­(2)­
for­continuous­spraying.
•­ Point­the­spray­nozzle­at­the­surface­to­
be­sprayed­and­press­the­trigger­lever­
(2)­on­the­pistol­grip­(1)­for­several­
seconds.
Cleaning
Do not spray the device with water
or clean it under running water.
There is a risk of electric shock and
the device could be damaged.
Switch the device off before cleaning
and remove the battery from the
device. Risk of electric shock!
Clean­the­device­immediately­after­each­
use.
38
•­ Clean­the­container­with­clean­water­
while­wearing­personal­protective­
equipment­(e.g.­gloves,­safety­googles).­
Cleaning the inside:
after use with water
•­ Empty­the­container­via­the­filler­ope-
ning and allow the container to dry out
completely.
after use with plant protection
products
•­ Clean­the­container­with­clean­water­
while­wearing­personal­protective­
equipment­(e.g.­gloves,­safety­googles).­
Dispose­of­the­liquids­in­accordance­
with­the­instructions­provided­by­the­
manufacturer­of­the­water-soluble­plant­
protection­agent.
Cleaning the outside:
•­ Clean­the­outside­of­the­device­with­a­
damp­cloth.­Do­not­use­any­detergents­
or­solvents;­these­might­attack­the­plas-
tic­parts­of­the­device.­Make­sure­that­
no water can get into the interior of the
device.­Penetration­of­water­into­the­
electrical­device­increases­the­risk­of­
electric shock.
Cleaning when the spray nozzle is
clogged
If­foreign­bodies­have­accumulated­in­the­
spray­nozzle­(8)­and­the­spray­nozzle­is­
blocked,­clean­it­as­follows­(never­blow­it­
out­with­your­mouth):
1.­ Clear­the­hole­in­the­spray­nozzle­(8)­
of residue with a needle or thin wire.
2­ Rinse­the­spray­nozzle­with­clear­water.
3.­ Allow­the­spray­nozzle­to­dry.­