Publicidad
Idiomas disponibles
Idiomas disponibles
GENERAL ASSEMBLY INSTRUCTIONS
A Phillips head screwdriver is required.
2
6
8
9
12
12
12
13
17
18
WARNING:
SURE THE PLUG IS DISCONNECTED BEFORE ASSEMBLING THE WET/DRY VACUUM.
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT EXPOSE TO RAIN.
UNPACKING YOUR WET/DRY VACUUM & GENERAL ASSEMBLY
4. Remove the contents from inside the collection tank. Make sure you have all contents as listed
5. Turn the collection tank on its side and insert the two casters into the sockets on the bottom of
the base and tighten with supplied screws. Verify that the casters are mounted correctly. Do not
6. Insert the wheel axle into the rear wheel housing on the vacuum base. Insert a washer onto the
axle followed by a rear-wheel and insert another washer. Insert the locking pin into the hole on
the end of the axle to lock the wheel. Snap the hub cap onto the wheel. Repeat the same steps
7. Position the hose storage rack as illustrated. Fully insert one end of the hose storage rack into
the slot illustrated by the arrow, then pull the other end of the hose storage rack to align with the
3
7a
10
14
19
DO NOT PLUG THE POWER CORD INTO A POWER OUTLET. MAKE
4
5
7b
7c
11
11
15
16
8
7d
Publicidad
