Assembly; Blade Installation - Ducati DBC 3300M Manual De Instrucciones

6. ASSEMBLY

• Push the l part of the rod (1) right down until
the latch (2) slots into the hole (3) in the rod.
This is easier to do if you rotate the bottom
of the rod (6) slightly in both directions. The
latch (2) is in place when it is completely
lodged in the hole.
• Lastly, press the latch cover(5) and then
tighten the knob (4) securely.
Do not attempt to disassemble
the two special screws.
WARNING
The two clamps position has
been adjusted at a suitable
place, do not attempt to remove
or move them. Otherwise, it
CAUTION
can result in serious personal
injury.
Installing plastic shield
Install the safety cover on the shaft with the
safety cover bracket and the screws provided.
Tighten the screws after setting the safety
cover bracket at the appropriate position.
Owner's manual

Blade installation

• Insert the hex key (2) into the specific hole
in the angle transmission (3) and rotate the
nut (7) by hand until the hex key enters the
inner hole, blocking rotation.
• Unscrew the nut (7) in a clockwise direction.
• Pull out blade cover (6) and the blade press
board(5).
• Ensure that the grooves in the key gasket
(4) mach up perfectly with the angle trans-
misson(3).
• Install the blade (1) and the blade press
board(5).
• Refit the blade cover (6) and the nut (7),fully
tightening it in an anticlockwise direction.
• Remove the hex key (2)
English
35
35