What To Do In Case Of A Problem - Novy 1773/2 Instrucciones De Uso Y De Instalacion

WHAT TO DO IN CASE OF A PROBLEM

The hob or the cooking zone doesn't start-up :
• The connection to the network is wrong.
• The protection fuse has disconnected.
• The locking function is activated.
• The sensitive keys are covered with grease or water.
• An object is put on a key.
The control panel displays [ U ]:
• There is no pan on the cooking zone.
• The pan is not compatible with induction.
• The bottom diameter of the pan is too small.
The control panel displays [ E ] :
• The electronic system is defective.
• Disconnect and reconnect the hob at the circuit breaker.
One or all cooking zone cut-off :
• The safety system is activated.
• You forgot to turn off the cooking zone for a long time.
• One or more sensitive keys are covered.
• The pan is empty and its bottom overheated.
• The hob also has an automatic reduction of power level to prevent overheating
Continuous ventilation after turning off the hob :
• This is not a failure; the fan continues to run to protect the electronic components.
• The fan cooling stops automatically.
The automatic cooking system doesn't start-up :
• The cooking zone is still hot [ H ].
• The highest power level is set [ 9 ].
The control panel displays [ L ] :
• Refer to the chapter "control panel locking" page.
The control panel displays [ U ] :
• Refer to the chapter "Keep warm".
The control panel displays [ II ]:
• Refer to the chapter "Stop&Go".
The control panel displays [
• An object or liquid covers the control keys. The symbol disappear as soon as the key is
released or cleaned.
The control panel displays [ E2 ] :
• The hob is overheated, let it cool and then turn it on again.
The control panel displays [ E8 ] :
• The air inlet of the ventilator is obstructed, release it.
The control panel displays [ U400 ] :
• The hob is not connected to the network. Check the connection and reconnect the hob.
The control panel displays [ Er47 ] :
• The hob is not connected to the network. Check the connection and reconnect the hob.
If one of the symbols above persists, call the SAV.
] or [ Er03 ] :
21