Operation; Fueling - Efco DS 3500 S Manual De Instrucciones

Fueling

en
Do Not Smoke!
This product is powered by a 2-cycle engine
and requires pre-mixing gasoline and 2-cycle
oil. Pre-mix unleaded gasoline and 2-cycle
engine oil in a clean container approved for
gasoline.
RECOMMENDED FUEL: THIS ENGINE IS
CERTIFIED TO OPERATE ON UNLEADED
GASOLINE INTENDED FOR AUTOMOTIVE
USE WITH AN OCTANE RATING OF 89 ([R +
M] / 2) OR HIGHER.
Mix 2-Cycle Engine Oil with gasoline according
to the instructions on the package. We strongly
recommend the use of 2% (50:1) Efco
Two Cycle Engine Oil, which is specifi cally
formulated for all Efco air-cooled two-stroke
engines.
The correct oil / fuel proportions shown in the
table below are suitable when using the Efco
Two Cycle Engine Oil or an equivalent high-
quality engine oil (JASO specifi cation FD or
ISO specifi cation L-EGD).
When oil specifi cations are NOT equivalent or
unknown use 4% (25:1) fuel / oil mixing ratio.
CAUTION:
AUTOMOTIVE OIL OR
2-CYCLE OUTBOARD OIL.
CAUTION:
- Match your fuel purchases to
your consumption; don't buy
more than you will use in one
or two months;
- Store gasoline in a tightly-
closed validate container in a
cool, dry place.
16

OPERATION

DO NOT USE
CAUTION -
never use a fuel with an ethanol
percentage
gasohol (mixture of gasoline and
ethanol) up to 10% ethanol or E10
fuel are acceptable.
When using an oxygenated gasoline a good
practice of fuel management is necessary.
Gasoline oxygenated with alcohol readily
takes up water when it is present; the water
may be condensed out of humid air or be a
contaminant in the fuel system, including tank.
The use of oxygenated gasoline may cause
the occurrence of vapor-lock easier.
NOTE - Prepare only the quantity of mixture
required for immediate use; do not leave fuel
in the tank or a container for a long time.
Were commend the use of the additive if the
mixture is to be stored for 30 days.
Alkylate gasoline
CAUTIONS – Alkylate fuels have
different density than normal fuel.
Therefore engines, set with normal
fuel, need different H jet regulation
to avoid critical issues. For this
operation it's necessary turned at
a Licensed Service Dealer.
For the mixture,
higher than 10%;