Preparation For Cutting - Efco DS 3500 S Manual De Instrucciones

Fuel Mixture
2-Cycle Engine Oil (25:1) 4%
Gasoline . . . . . . . . . . . . . . Oil
1 Gallon (US) . . . . . . . . . . 5.2 oz.
1 Liter . . . . . . . . . . . . . . . . 40 cc (40 ml)
2-Cycle Engine Oil (50:1) 2%
Gasoline . . . . . . . . . . . . . . Oil
1 Gallon (US) . . . . . . . . . . 2.6 oz.
1 Liter . . . . . . . . . . . . . . . . 20 cc (20 ml)
Filling the Tank
W A R N I N G : F o l l o w s a f e t y
instruction for fuel handling.
Always shut off engine before
fuelling. Never add fuel to a
machine with a running or hot
engine. Move at least 10 feet (3 m)
from refuelling site before starting
engine. DO NOT SMOKE!
1. Clean surface around fuel cap to prevent
contamination.
2. Loosen fuel cap slowly.
3. Carefully pour fuel mixture into the tank.
Avoid spillage.
4. Prior to replacing the fuel cap, clean and
inspect the gasket.
5. Immediately replace fuel cap and hand
tighten. Wipe up any fuel spillage.
WARNING: Check for fuel leaks,
if any are found, correct before
use. Contact a Servicing Dealer if
necessary.
OPERATION

Preparation for Cutting

WARNING: When using rigid
blades (only S and T models),
avoid cutting close to fences,
sides of buildings, tree trunks,
stones or other such objects that
could cause the brush cutter to
kick out or could cause damage
to the blade. We recommends use
of the nylon line heads for such
jobs. In addition, be alert to an
increased possibility of ricochets
in such situations.
WARNING: The brush cutter is
normally to be used at ground
level with the cutting attachment
parallel to the ground. Use of a
brush cutter above ground level
or with the cutting attachment
perpendicular to the ground may
increase the risk of injury, since
the cutting attachment is more
fully exposed and the brush cutter
may be more diffi cult to control.
Never use your brush cutter as a
hedge trimmer.
WARNING: If the blade loosens
after being properly tightened,
s t o p wo r k i m m e d i a t e ly. T h e
retaining nut may be worn or
damaged and should be replaced.
Never use unauthorized parts
to secure the blade. If the blade
continues to loosen, see your
dealer. Never use a brush cutter
with a loose blade.
Basic Cutting Procedure
1. Wear non-slip gloves for maximum grip and
protection.
en
17