Publicidad
Idiomas disponibles
Idiomas disponibles
2
FINAL WATER CONNECTION
a
Brass Nut
Ferrule
1/4"
Plastic
Tube
NOTICE
Property Damage: Join remaining tube
to cold water supply only.
3
TURN ON WATER & CONNECT POWER
a
Scalding Hazard: The faucet dispenses near-boiling
(212ºF) water which can instantly cause scalds or burns.
Use care when operating this appliance.
4
REPLACE FILTER EVERY 6 MONTHS
a
Refer to the Performance Data Sheet for InSinkErator Filter System Models
F-1000S or F2000S. Contact an authorized InSinkErator service agent for repairs
or replacement components. Replacement filters F-1000 and F-2000 can be
ordered by calling 800-558-5700, visiting shop.insinkerator.com, or by contacting
an authorized InSinkErator reseller.
The F-1000S is tested and certified by NSF International against NSF/ANSI Standard
42 in the following InSinkErator Systems Only: GN1100, HC1100, GN2200, HC2200,
GN2215, HC2215, H3300 or HC3300 for the reduction of the claims specified on the
Performance Data Sheet.
The F-2000S is tested and certified by NSF International against NSF/ANSI Standards
42 and 53 in the following InSinkErator Systems Only: GN1100, HC1100, GN2200,
HC2200, GN2215, HC2215, H3300 or HC3300 for the reduction of the claims
specified on the Performance Data Sheet.
44688_RevE_2023_04_26.indd 6
44688_RevE_2023_04_26.indd 6
Brass
Insert
Add the next replacement date to your calendar
(6 months from today) and write it on the enclosed
sticker and attach filter label sticker to cabinet door
or another convenient location for reference.
For your convenience and savings, scan this QR
code to sign up for our filter subscription or filter
reminder service.
1-800-558-5700
Install a T-fitting (not included)
onto the cold water supply line.
Install dedicated water control valve
with 1/4" compression fitting.
At the end of the white 1/4" tube
from the filter or quick-connector,
slide the supplied brass nut and
ferrule over the tube and then push
in the brass tube insert.
Insert the white 1/4" tube into the 1/4"
compression fitting and tighten.
Turn on the water supply.
Depress the dispenser's HOT handle
and hold it until water flows from the
spout (approximately 1 to 2 minutes).
Flush 3 gallons (11.4 L) through filter
before first use (approximately 4
minutes).
Check all connections to ensure they
are tight and that there are no leaks.
Pressure: 30-80 psi (207-550 kPA)
Temperature: 33˚F - 100˚F
Flow Rate: 0.75 gpm
Capacity: 500 gallons
262-233-2231
5
6/23/23 12:44 PM
6/23/23 12:44 PM
Publicidad
