Publicidad
Idiomas disponibles
Idiomas disponibles
4. Close the lid: Make sure the silicone gasket is seated properly inside the lid. Hold the
lid handle and put the lid on the cooker; rotate the lid counterclockwise approximately
30 degrees until the lid is aligned with the "CLOSE mark on the cooker. (See picture 6)
5. Install the condensation collector. (See picture 7)
6. Adjust the Exhaust Valve to the SEAL position before cooking. The Float Valve must
be fully down to properly seal the pot before cooking. (See picture 8)
If using the Slow Cook function mode, put the pressure valve to the VENT
position.
If using the other cooking function modes, put the valve to the SEAL position.
NOTE: Please note that the Exhaust Valve will be loose when you are not using the
appliance for cooking. It will rock slightly and can turn 360°manually. Once the
Exhaust Valve is in operation and the pressure has built up to its capacity, the Exhaust
Valve will tighten securely, only allowing itself to be turned to the right to vent when
you are facing the front of the cooker. Once all the pressure has released, it will
become loose again.
7. Connect to the power. The LED display shows "00:00" and it enters into standby state.
6
7
8
19
Publicidad
