Kärcher VHP Serie Manual Del Operador página 13

Check Water Heater Coil For Leaks
With the burner "OFF" start the pumping machine and
allow to run for a few minutes. Look into the burner
compartment with a drop light or flashlight. If no leak is
visible, then subsequent water dripping from the coil
will be from condensation in the flue gases when the
burner is on, as described in the previous paragraph.
PRE-START CHECK LIST
Is machine protected from downdraft
and excessive wind?
Is machine shielded from moisture or
water spray?
Is the voltage correct and circuit
breaker and supply cord adequate
according to specifications and
serial plate notation?
Is the machine electrically
grounded?
Is there ample water supply?
Have all flammable liquids or gases
been removed from installation
location?
Is the machine properly vented to
allow adequate air flow?
Is there an adequate gas supply for
the BTU rating of the burner?
Have gas lines been checked for gas
leaks?
Have all operators using this
machine been instructed properly
& have they read the manual?
Has the machine been installed
according to the instructions in the
operator's manual?
Is the incoming gas supply pressure to
the machine between 6-14 water
column inches or 1/2 psig?
VHP 2-1500 / 3-2000 Operator's Manual 8.913-949.0 - AU
Instructions for lighting
WARNING
RISK OF FIRE OR
EXPLOSION:
FOLLOW
INSTRUCTIONS
EXACTLY
YES NO
explosion may result causing property damage,
personal injury or loss of life.
AVERTISSEMENT: Si ces directives ne sont pas
suivies à la lettre, un incendie ou une explosion
pourrait survenir et entraîner des dommages à la
propriété, des lésions corporelles ou la mort.
1. This machine has a pilot which must be lighted by
hand. When lighting the pilot, follow these instruc-
tions exactly.
2. BEFORE LIGHTING smell all around the
appliance area for gas. Be sure to smell next to the
floor because propane gas is heavier than air and
will settle on the floor.
For your safety:
WHAT TO DO IF YOU SMELL GAS
a. Do not try to light any appliance.
b. Do not touch any electrical switch; do not use
any phone in your building.
c. Immediately call your gas supplier from a neigh-
bor's phone. Follow the gas supplier's instruc-
tions.
d. If you cannot reach your gas supplier, call the
fire department.
3. Use only your hand to push in or turn gas control
knob. Never use tools. If the knob will not push in
or turn by hand, don't try to repair it, call a qualified
service technician. Force or attempted repair may
result in a fire or explosion.
4. Do not use this machine if any part has been under
water. Immediately call a qualified service techni-
cian to inspect the machine and to replace any part
of the control system or any gas control that has
been under water.
Operations
WARNING: If "NO" has been
checked on any of the above ques-
tions, do not operate.
AVERTISSEMENT: Si la réponse à
l'une des questions ci-dessus est
« NON », ne pas utiliser la
machine.
WARNING: If you do not follow
instructions exactly, a fire or
13