Setting Up Your Machine; Power/Light Switch - Singer XL-420 Manual De Instrucciones

SETTING UP YOUR MACHINE

Be sure to wipe off any surplus oil from needle plate area
before using your machine the first time.
POWER LINE CORD/FOOT CONTROL
Connect the plug of the power line cord into the cord
socket (1) and your wall outlet (2) as illustrated.
Connect the foot control plug into the machine socket (3),
when using sewing machine only.
NOTE: In sewing mode, the machine can be operated either
with or without the foot control (see page 28 - 29).
Always disconnect the machine from power
supply by removing the plug from the wall-
outlet.

POWER/LIGHT SWITCH

Your machine will not operate until the power/light switch
is turned on. The same switch controls both the power and
the light.
When servicing the machine, or when changing needles
or lights, etc., the machine must be disconnected from the
power supply.
Power/light switch "OFF"
Interrupteur moteur/lumière "OFF"
Interruptor corriente/luz "OFF"
SPOOL PINS
HORIZONTAL SPOOL PIN for normal
thread spool
Place thread spool on the pin and secure with a spool cap
to ensure smooth flow of thread.
VERTICAL SPOOL PIN for large thread
spool
Attach the spool pin. Place felt disc over it. Place a thread
spool on the spool pin.
10
Spool pin cap
Couvre-fil
Tapa del pasador carrete
Set power/light switch at
"OFF"
Mettez l'interrupteur moteur/
lumière sur "OFF".
Poner el Interruptor de corriente/
luz de velocidad en "OFF"
Pin Pin
Butée
Pasador
XL-550-P04-1.eps
Spool
Bobine
Carrete
Felt disc
Rondelle feutre
Disco del pasador carrete
Vertical spool pin
Porte-bobine vertical
Pasador de carrete vertical
Thread retaining slit
Fente de retenue de fil
Ranura de retención de hilo
Spool Spool pin
Bobine Porte-bobine
Carrete Pasador carrete
Machine socket
Connecteur de la
machine
Conector de la máquina
2
1
3
Power line cord
Cordon
Cordón de la linea eléctrica
Foot control
Rhéostat
Control por pedal
Power/light switch "ON"
Interrupteur moteur/lumière "ON"
Interruptor corriente/luz "ON"