FUNCTIONS OF OPERATION SWITCH
PANEL
1. TACKING STITCH MODE BUTTON
Push this button and tacking stitch can be done with LED lit.
The sewing machine makes 4 tiny tacking stitches to tie off
the sewing on all patterns. The position of the tacking stitches
will be at the exact spot in the pattern where the tacking stitch
button is pushed.
2. NEEDLE STOP POSITION SELECTOR BUTTON
When the machine is turned on, needle is set at its up-stop
position with upper LED lamp lit. When the button is pushed,
needle is set at its down-stop position with lower LED lamp
lit. Push it again and it will return to its up-stop position with
upper LED lamp lit.
3. REVERSE STITCH BUTTON
Reverse sewing is carried out by pushing the reverse stitch
button. The machine will sew 4 stitches in reverse and stop.
4. START/STOP BUTTON
When the Start/Stop button is pushed, the machine starts
slowly, and when the button is pushed once more, the
machine stops.
However, when foot control is plugged, the Start/Stop button
will be inactive.
5. LED INDICATOR
Green light indicates machine is ready to start.
Red light indicates machine is operating.
Flashing red light indicates a problem or an error.
* Flashing for 2 - 3 seconds shows that an incorrect
operation was made.
* C o n t i n u o u s f l a s h i n g i n d i c a t e s t h a t t h e m a c h i n e
malfunctions.
6. SPEED CONTROL LEVER
Sliding the lever sets desired sewing speed. When foot control
is used, the lever serves as a top speed limiter.
Machine occasionally moves lower speed when it is cold or
when you sew thick fabric.
The lower speed continues until you stop and it will be high
speed after a while if the reason is from cold machine.
If the low speed is due to thick fabric, the lower speed
continues.
28
Reverse stitch function
for straight and zigzag
stitches
Fonction couture
arrière pour les points
droits et zigzags
Función de costura
hacia atrás para
costuras rectas y
zigzag
Tacking stitch function
for tie-off of other
stitches
Fonction de point
de faufilage pour la
jonction avec d'autres
points
Función de remate
para terminación de
otras puntadas.
1
2
3
4
5
6