Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly
Installing the Handwheel Knob
1. Locate the handwheel knob and screw in the loose
parts bag.
2. Use the hex "L" wrench from the tool box to remove the
screw from the center of the handwheel and remove
the handwheel from the unit.
3. Place the screw through the back of the handwheel
and secure the screw to the knob on the front of the
handwheel.
4. Place the handwheel back on the elevation shaft and
reinstall the screw in the center of the handwheel.
Alignment (Adjustments)
Extension Assembly Alignment
WARNING: To reduce the risk of injury from unex-
pected starting or electrical shock, do not plug the
thickness planer in. The power cord must remain
unplugged whenever you are adjusting or aligning
the thickness planer.
NOTE: Align only one extension at a time. Elevate the
motor enough to give a proper view of the table body and
clearance of the knives.
WARNING: Knives are extremely sharp and could
seriously injure your hands or arms.
1. Place a straight edge across table body and over
infeed extension as shown. Loosen locking nut and
adjust each side of the table until the straightedge
touches the outer edge of table extension. Tighten the
locking nuts.
2. Repeat step 1 for outfeed extension.
Adjusting the Thickness Indicator
The elevation indicator is preset at time of manufacture. To
check indicator select a piece of stock at least 30 cm (12")
long and 19 mm (3/4") thick. Set planer to 17 mm (11/16")
and run stock through planer. Measure wood after planing
and if necessary, loosen screws to adjust elevation indica-
tor to agree with measurement.
Screw
M5 x 0.8-10
Straightedge
Table
Extension
33
Knob
Planer
Table Body
~
Locking Nut
Publicidad
