Publicidad
Idiomas disponibles
Idiomas disponibles
Using the dryer
Features and
appearance
will vary.
Power
A
Press to "wake up" the display. If the display is active, press to put the dryer into idle mode.
NOTE: Pressing Power does not disconnect the appliance from the power supply.
Start and Pause
B
Press Start to begin the cycle. NOTE: The door must be closed for the dryer to start the cycle. Pressing Start
again will pause the cycle, the Start light will blink and "Pause" will display.
To continue the cycle, press Start again.
Display and Status Lights
C
The display shows the approximate time remaining until the end of the cycle.
In addition, this display will show the dryer status:
Pause
(on some models)
WiFi
(on some models)
Controls
Sensing
Clean Lint Filter
Vent Blocked
(on some models)
Sensing
Drying
Cooling
Done
Vent + Test
Tank Low
(on some models)
Empty
(on some models)
Less/Auto/More
(on some models)
6
A
C
NORMAL
Cottons
MIXED LOADS
DELICATES
JEANS
DOWNLOADED
B
G
P
A
C
NORMAL
Cottons
MIXED LOADS
DELICATES
JEANS
DOWNLOADED
B
G
O
A
C
NORMAL
Cottons
MIXED LOADS
Clean Lint Filter
Sensing
Drying
Cooling Done
DELICATES
Vent
Blocked
Test
JEANS
Washer Link
DOWNLOADED
B
K
The Start/Pause light will flash and the message "Pause" will show in the display when the
dryer's cycle is paused. The cycle may be re-started by pressing the Start button.
Will allow your appliance to communicate with your smartphone for remote appliance
monitoring control and notifications.
The dryer is locked - will blink once if you press any button or turn the cycle knob.
Indicates the dryer is sensing the level of dampness to determine estimated cycle time
remaining.
The Clean Lint Filter light will stay on for 15 seconds after the cycle stops.
The Vent Blocked light indicates an issue has been found due to reduced airflow from a
possible blocked or restricted vent. Checking and/or cleaning the vent system is recommended.
See the, "Vent Blocked" light is on in the Troubleshooting Tips section.
Garments need additional time to be dried.
Clothes dryer is removing moisture.
Air fluff cooling time after drying process.
Cycle has been completed and it will display the legend "END".
Venting system diagnostic test.
The Fabric Refresh tank only has liquid for two more loads. Refill the tank.
The Fabric Refresh tank is empty and must be refilled before running another cycle with
Fabric Refresh enabled.
Fabric Refresh is enabled and at the displayed disposing level.
E
G
TOWELS
Sheets
BULKY
QUICK DRY
SANITIZE
TIMED DRY
L
E
G
TOWELS
Sheets
BULKY
QUICK DRY
SANITIZE
TIMED DRY
L
E
G
TOWELS
90 min
Hot
Max Dry
Sheets
60
BULKY
40
20
QUICK DRY
10
No Heat
Damp
Time
Temp
Level
SANITIZE
TIMED DRY
ecoDry
Wrinkle Care
D
H
L
F
O
N
H
M
F
D
N
H
D
F
J
M
My Cycle
Hold 3s to Save
Damp Alert
I
M
J
49-3000244 Rev 7
Publicidad
