Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting Tips... Before you call for service
Problem
Static occurs
No fabric softener was used
Overdrying
Synthetics, permanent press
and blends can cause static
Collars and
The dryness monitor senses
waistbands still
that the body of the clothes
wet at end of
is dry
cycle
Slight variation
This is normal
in metallic color
Dryer continues
Wrinkle Care was selected
to tumble after
display says
Complete
Water on floor in
Loose water hose connection
back of dryer
Hose missing rubber washer
at connection with valve
Garments still
Too many garments
wrinkled after
Lint filter not clean
steam cycle
Load is children/infant
garments
Door is too
Steam and fabric refresher
foggy to see
condenses on inner door
clothes during a
steam or Fabric
Refresh cycle
Water seen on
Steam and fabric refresher
inside of door
condenses on these surfaces
and top of lint
filter when
opening door
after steam or
Fabric Refresh
cycle
Small areas
Steam condenses on inner
on clothes are
drum
damp after
steam or Fabric
Fabric refresher condenses
Refresh cycle
on inner drum
Small amount of
Inadequate load size for
water on floor in
steam cycle selected, excess
front of dryer
steam condenses inside
cabinet and leaks out
Inadequate load size for
Fabric Refresh setting cycle
selected, excess fabric
refresher condenses inside
cabinet and leaks out
49-3000244 Rev 7
Possible Causes
What To Do
Try a fabric softener.
Bounce
Fabric Conditioner Dryer Sheets have been approved for
®
use in all GE Appliances dryers when used in accordance with the
manufacturer's instructions.
Try a fabric softener.
Adjust setting to Damp.
Try a fabric softener.
Choose QUICK DRY or TIMED DRY to dry damp collars and
waistbands. In the future, when drying a load with collars and
waistbands, choose Max Dry.
Due to the metallic properties of paint used for this unique product,
slight variations of color may occur due to viewing angles and
lighting conditions.
Ensure Wrinkle Care option is not selected.
Tighten connection.
Install rubber washer provided with hose.
Load fewer garments; manually increase time.
Clean lint filter
Use the STEAM Refresh cycle.
This is normal.
This is normal.
If using the STEAM Dewrinkle cycle, manually reduce the cycle
time. If using the STEAM Refresh cycle, add more garments to
the load.
If using the MORE setting on a Fabric Refresh cycle, with small
loads, it may cause spots. Use AUTO or LESS setting to prevent
damp spots.
If using the STEAM Dewrinkle cycle, manually reduce the cycle
time. If using the STEAM Refresh cycle, add more garments to
the load.
Using the More setting on a cycle, with small loads, may cause
spots. Use Auto or Less setting to prevent damp spots.
17
Publicidad
