Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
Set up
Esta estufa de terraza debe instalarse en una superficie plana y estable, lejos de cualquier material com-
bustible.
Remove fire pit from a carton and remove cylinder cargo from another carton, place them on any level,
●
non-combustible surface.
Place glass lava rocks into the fire pit around the burner evenly
●
Unscrew the button cap of igniter, put a piece of AAA battery into igniter compartment with anode ou-
●
tward, then screw the button cap
Take down the lid of cylinder cargo carefully and put it in the safety place.
●
Connect the hose to the stove pipe and tighten the clamps, the other hose end to the regulator.
●
CAUTION: Do not kink flexible gas hose. If it is kinked, a gas leak could occur
Instruction for connecting gas circuit to LPG cylinder:
Keep at hand suitable crossed screwdriver. Before assembly, make sure all protection packing material has
been removed. Flexible gas rubber hose and clamps are not supplied with this appliance and must be
used, according to National Rules in force. Refer to the specifications for the appropriate gas regulator and
consumption (g/h) (see table on page 14). The LPG cylinder should be standard one. Replacement must
be that specified in "Gas Requirements" section of this Instruction Manual. Be careful: do not kink flexible
gas rubber pipe of gas circuit.
Make sure appliance gas knob is turned "OFF" before assembling (see below Figure).
●
Position the LPG cylinder at the side of your appliance, not underneath, keeping in mind that the LPG
●
cylinder must be kept away from heat and in a safe position.
Connect the regulator to LPG cylinder by hand
●
Connect the hose to the appliance and the regulator. Tighten the screw of the hose clamp with a screw-
●
driver.
Manual ATALAYA.indd 17
17
10/7/19 9:43
Publicidad
