EINHELL GC-PM 40 S-P Manual De Instrucciones Original página 28

9. Troubleshooting guide
Warning: Switch off the engine and pull out the spark plug boot before making any checks or adjust-
ments.
Warning: If, after making an adjustment or repair to the engine, you let it run for a few minutes, remem-
ber that the exhaust and other parts will get hot. Do not touch these parts as they may burn you.
Fault
The equipment
does not operate
smoothly and vibra-
tes intensively
The engine does
not start
Engine does not run
smoothly
Lawn turns yellow,
uneven cut
Grass chute is not
clean
The reprinting or reproduction by any other means, in whole or in part, of documentation and papers
accompanying products is permitted only with the express consent of the iSC GmbH.
Subject to technical changes
Anl_GC_PM_40_S_P_SPK7.indb 28 Anl_GC_PM_40_S_P_SPK7.indb 28
GB
Possible cause
- Bolts loose
- Blade attachment is loose
- Blade imbalanced
- Engine start/stop lever is not
pressed
- Throttle lever in wrong position (if
provided)
- Spark plug defective
- Fuel tank empty
- Fuel pump (primer) not actuated (if
provided)
- Air fi lter dirty
- Spark plug dirty
- Blade is not sharp
- Cutting height too small
- Engine speed too low
- Engine speed too low
- Cutting height too small
- Blade is worn
- Grass bag is clogged
- 28 -
Remedy
- Check bolts
- Check blade attachment
- Replace blade
- Press the engine start/stop lever
- Check setting (if provided)
- Replace spark plug
- Top up fuel
- Actuate the fuel pump (primer) (if
provided)
- Clean the air fi lter
- Clean the spark plug
- Sharpen blade
- Adjust to the proper height
- Set the throttle lever to max. (if pro-
vided)
- Set the throttle lever to max.
- Set properly
- Replace the blade
- Empty the grass bag
21.10.2016 08:26:27 21.10.2016 08:26:27