Publicidad
Idiomas disponibles
Idiomas disponibles
REF.54392
6.2 Select Injector Type
1) The test function can be entered after selec-
ting the type of fuel injection nozzle.
2) Different test joints are required for testing
different types of fuel injection nozzles. This
equipment only provides basic configuration,
more configuration of the connector need to
be purchased separately.
3) Due to the difference of internal structure,
some types of GDI nozzle cannot be tested
temporarily.
4) In addition to cleaning the fuel injection
nozzle, ultrasonic device can also clean fuel
pump, spark plug, and other small size parts,
but pay attention to the selection of appro-
priate cleaning agent.
6.3 Ultrasonic Cleaning
Injector Cleaner takes advantage of the pe-
netrability and cavitation impact wave cau-
sed by ultrasonic wave traveling through the
medium to provide powerful cleaning on ob-
jects with complex shapes, cavities and pores,
so that the stubborn carbon deposits can be
removed from the injectors.
Procedures
1) Place the injector/pump which has gone
through surface cleaning in the launder.
2) Add enough injector detergent into ultra-
sonic cleaner so that the liquid level is about
20mm above the needle valve of injectors /
whole pump.
3) Plug the pulse signal wire to injector / pump
respectively.
4) Select ultrasonic cleaning function and then
set the time.
5) Press ENTER key to run.
6) When the time is up, it will stop automatica-
lly as the beeper rings.
7) Take the injector / pump out of the launder
and wipe them with a dry soft cloth. Get ready
for next operation.
Note:
Do not let the ultrasonic cleaning running as
ultrasonic basin without injector cleaning de-
tergent. Otherwise damage may be incurred.
Do not let the pulse signal cables or plug dip
in the injector's body into the detergent.
· 25 ·
Publicidad
