Memco Memcom+ Guia De Instalacion página 10

Full Programming Options
Quickstart >
Tel. Numbers >
Alarm no. 1
Alarm no. 2
Alarm no. 3
Alarm no. 4
Tech.no.
Background no.
Call attempts
Settings >
Codice ID
Volume
Accessories >
System Config >
System Config+ >
HW Monitoring >
Lift Monitor
IP1 only
IP1+IP2 (Serv.)
Service Count
Interval
Live Count
Delays >
COP delay
MPS delay
TOC delay
Tech IP1 delay
Tech IP2 delay
Hangup delay
Answer delay
Messages >
Location
Reassurance
Guidance
Time / Date >
Time
Date
Advanced >
Passcode
Network ID
Next EN81 call
SIM PIN
PBX Frequency
Language
Relay Mode
Relay Override >
HW Config >
GMT Offset
DTMF RX
Menu Sections continued...
Messages
Messages >
Time / Date
The time and date can be set by entering the correct values and
confirmed by pressing #
Advanced Settings
Passcode
Enter the passcode required to enter standard programming mode
when EN81-28 mode is active. (up to 6-digits). This will also become
the passcode required to access the old menu structure. However,
from the idle screen you will have to press * PASSCODE #
Network ID
Set an extension number 1-8 where units share a phone line. All unit
IDs on a system need to be unique.
Next EN81 call
Details the next scheduled Background call for the unit.
SIM PIN
If the SIM card is locked, then the 4-digit code to unlock it can be
entered at menu option SIM PIN. If no PIN is required, leave as
0000.
PBX Frequency (Default 320)
Sets disconnect tone frequency (40-2000Hz in 40Hz steps), if
connected to a PBX which does not use standard tones.
Note: 640 is another commonly used PBX frequency.
Language
Set the language required by entering the following:
Language >
>
>
Location This is the only message that needs
recording. The location message is played
to the call centre receiving the alarm call,
to inform them of the location of the lift.
Reassurance
This is the message played to trapped
passengers as an alarm call is being
placed
Guidance
If the 'Guided' protocol has been
selected, this message will be played to
the call centre operator to ask them to
select whether to listen to the Location
message or to be connected to the lift car
immediately.
English
ü
German
û
French
û
Italian.
û
Spanish
û
10