Troubleshooting - Memco Memcom+ Guia De Instalacion

Troubleshooting

Telephone Line
Problem
"No Dial Tone" showing on LCD
"Number is not Recognised"
is heard coming from the
Memcom ?
+
It does not matter which number
is programmed into the unit, it
always dials the same number
Unit is working on the telephone
line, but dialling in is not possible
GSM
Problem
GSM unit is not working correctly
or is not recognized by the
Memcom Unit
+
Wiring
Problem
Only have one set of contacts on
the Alarm Push, these set off the
Alarm & Siren
Alarm Push button is not working
The sound quality of two-way
communication is poor
Solution
1. Disconnect Green Terminal Block and check voltage across Terminals 1 & 2 [24vdc-60vdc
dependent on the type of line used].
2. If no voltage is present, check the telephone socket and the travelling spares/flex used.
1. This is a BT Automated Message. Check the number/numbers are correct.
2. If you have a handset, connect it and check the telephone line.
3. If a PBX / PABX is used in the building insert the number required to get an outside line, in
front of the telephone number/s you enter in the unit.
4. 0800 telephone numbers do not work with emergency telephones.
1. If you have a Handset, check the telephone line. Lift the handset, and if the line is ringing
before any keys are pressed – it means the telephone line is a Hotline.
2. Enter **4 instead of a telephone number. Press # to confirm and select 'Hotline' as the
protocol. In Hardware Monitoring, de-select Phone line.
1. Enter the value 1 in Delays> Answer Delay, and check using a handset that the telephone line
can be dialled from an external telephone number. Change Delays> Answer Delay back to 2 after
test.
2. In the Hardware> System Config option, check that EN81-28 Mode is de-selected.
Solution
1. Check that in the Settings> Accessories, Memco GSM has been selected.
2. Check the polarity of the RING and TIP connections. RING to RING and TIP to TIP is required.
3. Check the SIM card used in a mobile phone, and ensure that the correct SIM card PIN number
has been entered in Advanced> SIM PIN
4. If necessary, deactivate the SIM Card PIN number and the Mailbox.
5. Once GSM has been set up correctly, disconnect it, then reconnect it to the Memcom
Solution
1. Remove the two wires from the Alarm Push and wire directly to Terminals 5&6, then wire two
spares from Terminals 9&15 to the back of the Alarm Push.
1. It may be that the Alarm Push button has not been pressed for long enough. Check Delays> In
Car Delay to see what delay has been set. The default is 3 seconds. Adjust accordingly, but do
not set as 0.
2. Check that the Alarm Push is wired to connections 9&15 without voltage.
3. Check if the circuit is N/O or N/C. If normally closed, in Settings> System Config, select N/C
Alarm Push.
4. Place a Short/Wire Link across Terminals 9&15 –This should trigger the Memcom
does, then the problem is with the alarm push or the wiring.
1. Check what the volume has been set to and adjust up or down accordingly.
2. If sound quality issues continue, consider changing the location of the Memcom
the microphone postioned in a suitbale positon and not located near VF signals.
3. If problems still persist, then it may be worth considering a COP speaker / mic accessory.
Please contact us for more information.
unit.
+
alarm, if it
+
unit, ensure
+
13