Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cut-out, this appliance
⚫
must not be supplied through an external switching device, such as a timer, or connected to a circuit that is
regularly switched on and off by the utility.
Preparation
This product includes a GLASS panel! Always use extreme caution when handling glass. Failure
to do so could result in personal injury or property damage.
Remove all parts and hardware from the carton and place them on a clean, soft, dry surface Check the parts list to
make sure nothing is missing. Dispose of packaging materials properly. Please recycle whenever possible.
You will need the following tools (not included): Phillips screwdriver; stud finder; level; tape measure; electric
drill; 1/4" wood drill bit, hammer.
Parts and Hardware
A – Fireplace
F - Decorative Crystals
Installation and Assembly
Rear View of Fireplace
19.7"
(50 cm)
G - Log set
Minimum 39.4"
(100 cm)
Minimum 19.7"
(50 cm)
B – Wood Screws
D - Remote Control
H - Plastic Tray
Step 1. Find a safe location.
Minimum clearance on each side:
19.7" (50 cm).
Minimum clearance below: 19.7"
(50 cm).
Minimum clearance above: 39.4"
(100 cm).
19.7"
Choose a location near an outlet so
(50 cm)
an extension cord is not required.
DO NOT position the unit directly
below a power outlet.
See Safety Information on pages 2
and 3 for warnings about safe
placement, safe installation, and
proper use of this product.
12
C – Drywall anchors
E - Wall Bracket
Fixed on back of firebox
Publicidad
