VENTE-UNIQUE LAO BEF-31WM Manual Del Usuario página 16

warnings.
Remote Control & Control Buttons Operation
BUTTON
ON: Enables control panel functions and remote
control. Turns on flame effect.
OFF: Disables control panel functions and remote
control. Turns off flame effect.
POWER
TIMER button: Controls timer settings to turn off
fireplace at selected time.
Settings range from 0.5 hours to 7.5 hours.
TIMER
FLAME button "+": Makes flame effect brighter.
NOTE: Flame effect stays on until power button is
turned off. Flame effect must be on for heater to
turn on.
FLAME
FLAME button "-": Makes flame effect dimmer.
NOTE: Flame effect stays on until power button is
turned off. Flame effect must be on for heater to
turn on.
FLAME
HEATER button: Turns heater on and off.
NOTE: The heater only works when the flame
effect is on. If the flame effect is off, the heater will
not turn on.
NOTE: To prevent overheating, the heater fan will
blow cool air for 8-10 seconds after the heater
HEATER
turns off.
BACK LIGHT button: Makes the decorative LED
back light effect changing.
NOTE: Back light effect stays on until power
button is turned off.
BACK
LIGHT
When the heater is first turned on, a slight odor may be present. This is normal and should not
NOTICE
occur again unless the heater is not used for a long period of time.
To improve operation, aim the remote control at the remote receiver, and DO NOT press the
NOTICE
buttons too quickly. Give the unit time to respond to each command.
15
FUNCTION ACTION & INDICATION
1. Press once. Indicator light turns on. Power
turns on. All functions enabled.
2. Press again. Flame effect turns off. Unit goes
to standby. All functions turn off.
1. Press once. Indicator light turns on. Timer is
set to 0.5 hours.
2. Press again until desired setting is
reached. Indicator lights show setting.
1. Press once. Flame brightness effect gets
brighter.
2. Press again. until desired setting is reached.
1. Press once. Flame brightness effect gets
dimmer.
2. Press again. until desired setting is reached.
1. Press once. Indicator lights up.
750W heater turns on and blows warm air.
2. Press again. Indicator lights up.
1500W heater turns on and blows hot air.
3. Press again. Heaters turn off.
The fan blows cool air for 10 seconds to allow
heater to cool down, then turns off.
1. Press once. LED back lights color effect gets
changing.
2. Press again until desired setting is reached.