Temperature Limiting Control
This heater is equipped with a Temperature Limiting Control. Should the heater reach an unsafe temperature, the
heater will automatically turn OFF. To reset:
1.Unplug the power cord from the outlet.
2.Turn the ON/OFF switch on the CONTROL PANEL to OFF. Wait 5 minutes.
3.Inspect the fireplace to make sure no vents are blocked, or clogged with dust or lint. If they are, use a vacuum to
clean the vent areas.
4.With the POWER switch in the OFF position, plug the power cord back into the outlet.
5.If the problem continues, have your outlet and wiring inspected by a professional.
Remote Control Battery Information
•
This remote control uses one CR-2025 battery (included).
NEVER dispose of batteries in Fire. Failure to observe this precaution may result in an
explosion. Dispose of batteries at your local hazardous material processing center.
Care and Maintenance
Cleaning
ALWAYS turn the heater OFF and unplug the power cord from the outlet before cleaning,
performing maintenance, or moving this fireplace. Failure to do so could result in electric shock,
fire, or personal injury.
NEVER immerse in water or spray with water. Doing so could result in electric shock, fire, or
personal injury.
Metal:
•
Buff using a soft cloth, slightly dampened with a citrus oil-based product.
•
DO NOT use brass polish or household cleaners as these products will damage the metal trim.
Glass:
•
Use a good quality glass cleaner sprayed onto the cloth or towel. Dry thoroughly with a paper towel or lint-free
cloth.
•
NEVER use abrasive cleansers, liquid sprays, or any cleaner that could scratch the surface.
Vents:
•
Use a vacuum or duster to remove dust and dirt from the heater and vent areas.
Plastic:
•
Wipe gently with a slightly damp cloth and a mild solution of dish soap and warm water.
•
NEVER use abrasive cleansers, liquid sprays, or any cleaner that could scratch the surface.
Maintenance
Risk of electric shock! DO NOT OPEN any panels other than the bulb replacement plate!
No user-serviceable parts inside!
ALWAYS turn the heater OFF and unplug the power cord from the outlet before cleaning,
performing maintenance, or moving this fireplace. Failure to do so could result in electric shock,
fire, or personal injury.
16